LMMS • Forums

Posted: **Wed Jul 19, 2017 2:57 am**

(I'm using LMMS 1.1.3, is this a feature in 1.2 already?)

I know this is simple, but it would be useful if you want a sample to loop/repeat, but start partway through the sound.

The loop point currently cannot be before the start point, but it does not have to be that way!

Posted: **Sun Jul 30, 2017 5:25 pm**

Couldn't you instead just add a volume/cutoff envelope with predelay?

Posted: **Thu Aug 17, 2017 1:53 am**

R1KAI wrote: ↑
Sun Jul 30, 2017 5:25 pm
Couldn't you instead just add a volume/cutoff envelope with predelay?

Well, then after the note is "played", it wouldn't make any sound until the delay is over. It should start playing immediately, but at a different location.

So... I'm pretty much asking that the two knobs (starting and looping points) are independent of each other. Moving one should not move the other.

Posted: **Fri Oct 20, 2017 1:08 pm**

Or, you could have a button that unlinks the knobs, in case you want them to stay linked. I don't know, I'm not the programmer.

LMMS • Forums

Allow sample loop point to be before starting point!

Allow sample loop point to be before starting point!

Re: Allow sample loop point to be before starting point!

Re: Allow sample loop point to be before starting point!

Re: Allow sample loop point to be before starting point!