janika wrote: ↑Sun Jun 02, 2019 2:39 pm
I spent so long yesterday altering a piece that was all written in 4/4 to swap sections of it to 7/8 time. It took a while before I realised the bar numbers were changing depending whether the play curser had just played in 8 or 7 beats, so setting up the automation was almost impossible!
I may not understand, but would this
https://youtu.be/sIToz0LIRIM not be ok?
It looks odd, but the output is fine i think?
Is yours different?
Maby i need to see the file..
btw, not any real difference between rc7 and rc8, så you dont need to re-install
---------
I have been asked how i specifically made this:
there are *two* automation tracks
1) The time-signatures *Numerator* value
2) The time-signatures *De-numerator* value
To rebuild this you
*Insert the two automation tracks
* set the time-signature
* drag the *Numerator* value into 1. automation track
* in same position drag the *De-Numerator* value into 2. automation track
*Extend the span of the two automation track-blocks so whole 1. wanted time-signature is covered#
Move play-head to position inside 2. wanted time-signature
* set the time-signature
* drag the *Numerator* value into 1. automation track in this new position
* in same position drag the *De-Numerator* value into 2. automation track
*Extend the span of the two automation track-blocks so whole 1. wanted time-signature is covered as before
Repeat as needed
The *important* thing is not to drag new Numerator / De-Numerators into song-editor *before* you have moved the play-head!
#It not *necessary* to drag it to cover the whole span, but it look more logical if you do
Should i make a video covering this method?