Page 1 of 1
[Solved] Project won't load
Posted: Mon Mar 09, 2015 7:43 pm
by apotterdd
I have a project with just 2 VSTs loaded in it and nothing else with just two bars of notes. I save the file fine but once the program is closed and then opened up later on the project file does not load all of the way and the program crashes. And even if I start the project over the same thing happens to it.
OS: Windows 8 64bit
LMMS: 1.1.3
RAM: 4 gigs
Not sure what else you need.
The VSTs were dvs Guitar and Revitar. I have the settings pointing at where I store my VSTs on my HD but the problem existed before that too so I'm really at a loss.
Any help is appreciated.
Re: Project won't load
Posted: Mon Mar 09, 2015 10:02 pm
by Sti-Jay
hmm, those vsts doesn't seem too big so unless they got a fault it shouldn't happen. Have you tried with a completely new project with these VSTs? Do you have automations in the project?
Re: Project won't load
Posted: Mon Mar 09, 2015 10:57 pm
by apotterdd
Nope no automations and I did try with just one of them loaded and had the same problem. Once the program is closed then opened later it still won't load and freezes.
Re: Project won't load
Posted: Tue Mar 10, 2015 12:05 pm
by musikbear
Do you have any effects in the vsts or in the channels for the vsts?
The culpit is most likely 'Revitar'
To test that, try a new project with only Revitar, and a few notes
What behavior do you get?
Re: Project won't load
Posted: Tue Mar 10, 2015 1:29 pm
by apotterdd
No effects were put on them. Revitar look like it's using up a lot of CPU that bar on top is going nearly all the way to the right with clicking and popping noises. Saved a test file, closed the program, loaded program then tried to load the file and it froze and crashed.
Did the same with DVS guitar and that one loaded. It's definitely the Revitar VST. Well that problems solved.