LMMS • Forums

A collaboration me and Douglas have been working on. Let me know what you think of it

https://soundcloud.com/user-64509083/rw ... l-breakout

I was just about to post this, but then I saw that you beat me to it!

Nice collab!

I would say that the snare drums lack definition. Perhaps it is masked by the other instruments?

D.Ipsum wrote: ↑

Sat Jul 08, 2017 8:55 pm

Nice collab!

I would say that the snare drums lack definition. Perhaps it is masked by the other instruments?

Oops, that's my fault!

More cuts in the higher frequencies + 200 Hz probably would have fixed that...

RWalsh wrote: ↑

Sat Jul 08, 2017 5:31 pm

A collaboration me and Douglas have been working on. Let me know what you think of it

https://soundcloud.com/user-64509083/rw ... l-breakout

Douglas wrote: I was just about to post this, but then I saw that you beat me to it!

Ahhh. This is fantastic.
Good work you two.

I like that fx voice effect sounding sound, that unexpectedly, comes in the track
and can be heard, from 59 to 1:10 secs and from 2:36 to 2:53 secs too.

That was immense fun!

brandystarbrite wrote: ↑

Sat Jul 15, 2017 4:07 pm

I like that fx voice effect sounding sound, that unexpectedly, comes in the track
and can be heard, from 59 to 1:10 secs and from 2:36 to 2:53 secs too.

There are three sounds there; two being TripleOscillator, and the other being LB302.

LB302 is pitched down two octaves, with a very large amount of distortion, the Cutoff Frequency all the way down, Env Mod all the way up, Decay at 0.5, and Resonance at 1. It was at the default bandlimited saw wave. It also had a StereoEnhancer at 28 samples, the default C* Plate 2x2, and some EQ so it fit better in the mix. This makes the acid sound that plays every other measure.

One of the TripleOscillators has a default plugin screen, except it is a Saw/Square/Moog wave, in that order top to bottom. I added some slight attack (0.05) and release (0.05), like you should with almost all your synths. I used the 2x Lowpass Filter, with a frequency of 600 and a Resonance of 3. For the cutoff frequency ENV, the DAHDSR (All the knobs in order) is 0, 0, 0, 0.3, 0, 0.1. I set the AMT for that to 0.38. I then used a Decimator with a Sample Rate of about 4400, the default C* Plate 2x2, and some EQ to help it fit into the mix nicely. This makes the "Aye" sound.

The second TripleOscillator is exactly the same as the first (unless I'm mistaken), except the cutoff frequency is 350 Hz and the DAHDSR is 0, 0.125, 2, 0.266, 0, 0.1. This makes the "Waah" sound.

RWalsh wrote: ↑

Sat Jul 08, 2017 5:31 pm

A collaboration me and Douglas have been working on. Let me know what you think of it

https://soundcloud.com/user-64509083/rw ... l-breakout

It's very good.

It would be interesting to make a remix, so that it is available in other genres.