Something new

[lokiilox]

I whipped this up a couple days ago but here ya go https://soundcloud.com/user-395953777/hearingfootsteps
tell me what ya think and what i could do better. still dont know how to use automation track in 1.1.3

[D.Ipsum]

Concerning the automation, have you read what is here: https://lmms.io/wiki/index.php?title=Wo ... Automation

Concerning your track, there is too much compression / limitation!
My headphones sizzle in a verry bad way.
On Audacity you can see that the track looks like a sausage! (although it is fashion, here, it is exaggerated).
The problematic saturation appears to be in the frequency band which extends from 0 to 250 Hz.
Since what extends from 0 to 20 Hz is barely audible (infrason), you can greatly attenuate what is there.

[brandystarbrite]

Good tune.
But I can hear, alot of distortion in this tune, which is not good.

It could be, that too much compression etc. could be causing it, as D.Ipsum suggested above.

Or, it could be, that your track is in the red zone and has alot of clipping instruments.
If so, always keep your track, slightly below 0 db. And try to make sure, it doesn't enter the red zone.
Read here, for some more info on this.
https://lmms.io/forum/viewtopic.php?f=7&t=3235&start=40

[lokiilox]

thnx for the advice guys ill keep it all in mind and your right it was in the red zone

[D.Ipsum]

The red zone on the master channel should be avoided. On any other channel, this is not a problem.