Audio Help
Posted: September 4th, 2017, 10:18 pm
Hey, does anyone know how to make a instrument play DISTINCTLY in both ears?
Hope that helps! Cheers!
Page 1 of 1
Re: Audio Help
Posted: September 5th, 2017, 5:38 am
What I usually do is pan the instrument into either the left or right channel, simply by using the Pan knob next to the volume.
Hope that helps! Cheers!
Hope that helps! Cheers!
Re: Audio Help
Posted: September 5th, 2017, 2:17 pm
Are you asking how to make mono?GingkathFox wrote: ↑September 4th, 2017, 10:18 pmHey, does anyone know how to make a instrument play DISTINCTLY in both ears?
Exactly same output in both ears?
Re: Audio Help
Posted: September 6th, 2017, 1:05 am
musikbear wrote: ↑September 5th, 2017, 2:17 pmAre you asking how to make mono?GingkathFox wrote: ↑September 4th, 2017, 10:18 pmHey, does anyone know how to make a instrument play DISTINCTLY in both ears?
Exactly same output in both ears?
distinctly >< same GingkathFox, you can clone your synth. The first panned hard left, the second hard right. And slightly modifies the clone(e.g.a few dB less, a little delay, another cutoff value, and so on).
With a single synth,you can do it with effects. Many effects allow you to set different values for the left and right channels.
For example, with the Multiband EQ, you have to uncheck the box "Link channels" (I don't know if this is the expression used in your language), and then you can put something like 220Hz = + 6dB left and -3dB right.
You have other effects that, by definition, do the job (reverb, chorus, etc.).
If it can help.
Re: Audio Help
Posted: September 10th, 2017, 11:08 pm
Ok thanx! I'll try that!D.Ipsum wrote: ↑September 6th, 2017, 1:05 ammusikbear wrote: ↑September 5th, 2017, 2:17 pmAre you asking how to make mono?GingkathFox wrote: ↑September 4th, 2017, 10:18 pmHey, does anyone know how to make a instrument play DISTINCTLY in both ears?
Exactly same output in both ears?
GingkathFox, you can clone your synth. The first panned hard left, the second hard right. And slightly modifies the clone(e.g.a few dB less, a little delay, another cutoff value, and so on).
With a single synth,you can do it with effects. Many effects allow you to set different values for the left and right channels.
For example, with the Multiband EQ, you have to uncheck the box "Link channels" (I don't know if this is the expression used in your language), and then you can put something like 220Hz = + 6dB left and -3dB right.
You have other effects that, by definition, do the job (reverb, chorus, etc.).
If it can help.