Synth1 has a setting for two modwheels. (Wheel MIDI)
So I set the first wheel to pitchbend, then dragged , through the wrench symbol on Vestige, midi control src1 into an automation track.
This does not seem to work though, as no pitchbending happens, after I made a graph in the automation track.
Could it be I need to use a midi controller with pithbend ?
A bit off topic:
I do have a midi controller, with a pitch bend wheel, but as we type its not working.
I have ordered a socket to solder on a circuit-board, An USB B socket, in a last attempt to fix this midi keyboard.
When I got this controller it was working, but you had to fiddle the USB cable, for the pc to see the controller.
An attempt to solder an USB cable directly to the circuit-board failed.
So I set the first wheel to pitchbend, then dragged , through the wrench symbol on Vestige, midi control src1 into an automation track.
This does not seem to work though, as no pitchbending happens, after I made a graph in the automation track.
Could it be I need to use a midi controller with pithbend ?
A bit off topic:
I do have a midi controller, with a pitch bend wheel, but as we type its not working.
I have ordered a socket to solder on a circuit-board, An USB B socket, in a last attempt to fix this midi keyboard.
When I got this controller it was working, but you had to fiddle the USB cable, for the pc to see the controller.
An attempt to solder an USB cable directly to the circuit-board failed.