LMMS • Forums

There are a few synths only playing on one speaker. Is there a way to account for a mono signal from a vst within lmms? I think that is what is causing it anyway. It is just a couple vst's doing it out of over 40 I use.

There might not be any replies due to the fact that my question may be mission impossible. But I remedied by exporting to an audio engine and converting the loop to mono once there.

There are a few synths only playing on one speaker

if you would list a couple other peeps could test on their system

might not be any replies due to the fact that my question may be mission impossible

no, just interesting :p

br.

Thanx 4 taking an interest in the post. "Acquit xx11" and "Asynth" were both doing this. I think lmms just jammed the mono signal into one speaker which sounded very odd and was very annoying. Particularly due to the fact that I had a couple hot loops going on with xx11. It is a cool vsti in my humble opinion. If you wanna take the challenge and make lmms play these in both speakers you are a step ahead of me because I just couldn't get 'er done.

easy solved, you will however not have any 'pan' possibillities
Insert a "Stereophonic-Matrix" in the instrument FX channel
Set
left-to-left: 1
left-to-right: 1
You have a centered sound or where the same signal comes from both speakers
(I tested only with Asynth -could not find an aceptable dl for the other)

Br.

I am good at the creative side of music: but the tech side; not so much. I bow to your higher level. Just so there is something in this for you bro: I got xx11 on vst4free. Acquit has some cool stuff on there you at least might wanna sample. Hey man: while I got you on here: how the hell do you load a preset bank into triangle 1. On triangle 2 I just click on "triangle 2" and a menu comes up. I can't get any kinda menu clicking anything on triangle1 and it rocks--I want more pre's on it!