Recently updated from version 1.1.3, and I'm having some problems with automation- not sure, though, if the change is intentional or not. When I set, for example, the volume of an instrument, I'll click one block in an automation track and Ctrl-drag a volume knob to it, it stays locked at that volume for the entire remainder of the song no matter how I try to change it. It didn't do that in 1.1.3- the volume would stay locked until the end of the block, then I could adjust the knob again afterward if I so desired and then drag it to another automation block at a different are of the song. This was really handy for changing the volume of an instrument over time, because I could just play a certain part of the song, adjust it until it sounded right, then lock it in with automation wherever I wanted. Now I can't do that because the first time I assign a knob to an automation block it stays locked where it is and I can't change it without going into the automation editor and just sort of guessing?
I tried turning off song-global automation but of course that didn't do anything. Was this change intentional?
I tried turning off song-global automation but of course that didn't do anything. Was this change intentional?